Attention: Read this so no one gets hurt

We design equipment with the user's safety in mind. You can avoid the potential hazards identified on this machine by following the procedures outlined below and elsewhere in the User Guide.

WARNING:Imporper installation, operation, or servicing may result in equipment damage or personal injury.

This equipment should only be installed, adjusted, and serviced by qualified technical personal who are familiar with the construction, operation, and potential hazards of this type of machine.

All wiring, disconnects, and fuses should be installed by qualified electrical technicians in accordance with electrical codes in your region. Always maintain a safe ground. Do not operate the equipment at power levels other than what is specified on the machine serial plate.

WARNING:Voltage hazard.

This equipment is powered by alternating current, as specified on the machine serial tag and data plate.

A properly sized conductive ground wire from the incoming power supply must be connected to the chassis ground terminal inside the electrical enclosure. Improper grounding can result in severe personal injury and erratic machine operation. Always disconnect and lock out the incoming main power source before opening the electrical enclosure or performing non-standard operating procedures such as routine maintenance. Only qualified personnel should perform troubleshooting procedures that require access to be electrical enclosure while power is on.

CAUTION:Equipment hazard.

Only a well trained engineer are allowed to rewire the injection robot from one interface to the other (i.e. From EU12 to EU67). Improper wiring will cause damage. Call SWITEK service (+86 18665171961) or send an e-mail to support@switek.biz if you're unsure or have any questions.